Chainsaws provide many years of work for a minimum of maintenance. The service time to make sure the saw that the devices do not let them down. For security reasons, you should only service your chainsaw when it has completely cooled, cut it with the candle. If you use an electric chainsaw make sure it is disconnected from everything. You should also gloves and eye protection.
For a safe and efficient operation with the correct chainVoltage is needed. As the chain brings considerable distances occur. After nine fifty-five cuts a new chain can be adjusted. The separation from the guide and binding occur in the forest, if the chain is loose. Premature wear of the chain and bar will be caused by a tight chain. A chain that is well regulated, easily and smoothly as they move pulled by a gloved hand. Binding or sagging of the chain should not occur. The chain tension checked and adjusted, if necessary,Before each use.
A manual or automatic chain oiling system is used in most chainsaws. Friction and heat created between the chain and guide bar without oil. The oil also helps the individual links in the chain smoothly at high speeds. Check the oil system before each use.
Tighten all screws and fasteners. This process must be performed before each use. Before I saw it every time you need to check the fuel system.
After every 10 hours, usingneed to clean or replace the air filter. Regularly changing the air filter, the saw can run cooler and consume less fuel.
The teeth must be lubricated for 10 hours after each use. You will know that lubrication is complete when a small amount of fat on the edge of the bar appears next to the pinion.
For 10 hours use of the guide must be off. Lower the bar on the promotion of a uniform pattern of wear on the floor and ceiling ofbar. Check the spark plug every 10 hours and clean or replace if necessary.
For 10 hours of use the spark arrester screen should be checked and cleaned and replaced if necessary. The spark arrester screen prevents sparks from leaving the port of discharge and damage to the operator or falling on flammable materials.
The fuel filter should be replaced every 20 hours. Poor performance can result if the filter is clogged.
To ensuremaximum performance, the following procedures as necessary to extend the life of your chainsaw. Take your chainsaw to an authorized dealer if the carburetor needs adjustment. The chain blades should be sharpened regularly, as they become opaque.
0 comments:
Post a Comment