As with all shop tools there are procedures that if you follow the lives of both your band saw and the blade extended. Correct tension, pressure, power, cleaning and lubrication are necessary to make the most of this tool.
There are certain precautions are taken to protect the blades from premature wear. For example, when the blades are new, they are too sharp, and any rigorous action can cause damage to teeth. To avoid prematurebearing manufacturers recommend a break in action for the new blades. This can be achieved by reducing the speed of hand in the first period, which are often half the normal speed with out. Reduce the amount of food in the beginning, for the first 50 square inches of material will also help you to say to bring more clarity in the blade, and is durable.
Even if you do not know what should be the normal discharge pressure for the material to be sure, start with a slight advance, and slowIncreasing the delivery pressure will be formed to correct chips braces (metal) or chip size (for wood). Be aware that there are certain alloys, such as those based on nickel, which are cut off at low speed and then they need to run more pressure.
Lubrication is a must for metal cutting bandsaw. Never use water as a lubricant or detergent, as it causes rust and block the proper functioning of the blades. A suitable lubricant is a mixture of a measure of high adhesionOil Chain Saw Bar with half a measure of kerosene or diesel fuel. Apply the mixture on both sides of the blade.
De-tension the leaf is required when cutting is completed and the blades are put to rest. Because of the heat produced during cutting, the sheet that extends a little 'and retire when cooled. Therefore, if the saw blade remains with the tension, the contraction has a negative effect on the leaves, sometimes causing a crack in it. These tensions are not necessaryis de-forms the tip of the blade and the pressure on the shafts and bearings.
The esophagus is an important part of the band saw and at the same time, the blade (usually this is done with the help of a stone) You must make sure to take the esophagus by moving the stone around the bottom of the esophagus with the front and the back teeth of the leaves.
Always try to maintain a ratio of no more than 65-70% and 30-35% of the sawdust in the air space between the bladeand the material we have seen. If you are not accustomed to this level, it is blocking the air that would otherwise push the dust, and the result is more heat generated, making the warm sawdust and ruin the lives of the band saw.
Last but not least, regular cleaning should be done to keep your band saw in perfect condition. The excessive accumulation of waste materials reduces the duration of the visa.
We also recommenda knife of high quality. Low-end quality of tool steel with blades less than that quickly becomes tedious, and a significantly higher risk of rupture knives are produced due to a poor weld.
0 comments:
Post a Comment